Sangean RCR-1 Especificaciones descargar pdf (Pagina 8)

Using the clock radio for the rst time

1. Place your clock radio on a at surface.

2. Fully extend the wire aerial located on the rear of your clock radio.

Place the wire antenna so that it is straight as possible extending

either above or below the radio.

3. Insert the adaptor plug into the AC socket located on the rear of

your clock radio. The display will show "time zone" for a few

seconds and then the display will ask you to set your time zone.

To set the time zone, press the Tuning up/down button and the

Select button to conrm. Your clock radio will show _ _: _ _ on the

display and the indicator will ash. The radio will scan for signal

and if a signal is found and received completely it will then show

on the screen without ashing. Now the radio will show the

current time.

4. If no signals are found, will be ashing on the display. It may

be necessary to relocate your clock radio to a position giving better

reception.

IMPORTANT:

The mains adaptor is used as the means of connecting the clock

radio to the mains supply. The mains socket used for the clock

radio must remain accessible during normal use. In order to

disconnect the radio from the mains completely, the mains adaptor

should be removed from the mains socket outlet completely.

Characters appearing on the LCD display indicates the clock radio

is connected to and powered from the mains supply.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 24 25

Sin comentarios

Sangean RCR-1 Especificaciones Pagina 8